Network UPS Tools
Power Devices support
Table of Contents

Click here to see reports of other supported models from Dynamix.

Note

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.2.1

Report #1 with driver megatec (detailed comments available)

This device is known to work with driver megatec, now replaced by the blazer_ser one. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

Some more detailed comments are available after the "Known supported…" sections.

Known supported variables

This device is known to support the following variables (values are just examples):

battery.charge

100.0

battery.voltage

12.70

battery.voltage.nominal

11.5

driver.name

megatec

driver.parameter.battvolts

4:12

driver.parameter.pollinterval

2

driver.parameter.port

/dev/ttyS0

driver.version

2.2.1-

driver.version.internal

1.5.13

input.frequency

50.2

input.voltage

234.0

input.voltage.fault

165.0

input.voltage.maximum

235.0

input.voltage.minimum

234.0

output.voltage

234.0

output.voltage.nominal

240.0

ups.beeper.status

disabled

ups.delay.shutdown

0

ups.delay.start

2

ups.load

0.0

ups.mfr

KEBO

ups.model

UPS-650VA VER7.00

ups.serial

unknown

ups.status

OFF

ups.status is always OFF; fixed in newer versions of NUT.

ups.temperature

0.0