Network UPS Tools - 5E1100iUSB

Click here to see reports of other supported models from Eaton.

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.7.1

This device is known to work with driver usbhid-ups.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

Some more detailed comments are available after the "Known supported…" sections.

This device is known to support the following variables (values are just examples):

battery.charge	`100`
battery.runtime	`3160`
battery.type	`PbAc`
device.mfr	`EATON`
device.model	`5E 1100i`
device.type	`ups`
driver.name	`usbhid-ups`
driver.parameter.pollfreq	`30`
driver.parameter.pollinterval	`2`
driver.parameter.port	`auto`
driver.parameter.vendorid	`0463`
driver.version	`2.7.1`
driver.version.data	`MGE HID 1.32`
driver.version.internal	`0.38`
input.voltage	`227.0`
outlet.1.status	`on`
outlet.desc	`Main Outlet` This variable can be set through upsrw to a string value upto the length of `20` characters.
outlet.id	`1`
outlet.switchable	`no`
output.frequency	`49.9`
output.frequency.nominal	`50`
output.voltage	`228.0`
output.voltage.nominal	`230` This variable can be set through upsrw to one of the following values: `200` `208` `220` `230` `240`
ups.beeper.status	`enabled`
ups.delay.shutdown	`20` This variable can be set through upsrw to a string value upto the length of `10` characters.
ups.firmware	`01.04.0018`
ups.load	`8`
ups.mfr	`EATON`
ups.model	`5E 1100i`
ups.power.nominal	`1100`
ups.productid	`ffff`
ups.start.battery	`yes` This variable can be set through upsrw to a string value upto the length of `5` characters.
ups.status	`OL CHRG`
ups.timer.shutdown	`-1`
ups.vendorid	`0463`

This device is known to support the following NUT’s instant commands:

Reported at:

Vendor/Manufacturer information: