Network UPS Tools
Power Devices support
Table of Contents

Click here to see reports of other supported models from Sysgration.

Note

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.0.5

Report #1 with driver megatec (detailed comments available)

This device is known to work with driver megatec, now replaced by the blazer_ser one. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

Some more detailed comments are available after the "Known supported…" sections.

Known supported variables

This device is known to support the following variables (values are just examples):

battery.charge

85.0

battery.voltage

26.20

battery.voltage.nominal

24.0

driver.name

megatec

driver.parameter.port

/dev/ttyS1

driver.version

2.0.5

driver.version.internal

1.5

input.frequency

49.0

input.voltage

208.0

input.voltage.fault

208.0

input.voltage.maximum

212.0

input.voltage.minimum

208.0

output.voltage

208.0

output.voltage.nominal

220.0

ups.beeper.status

enabled

ups.delay.shutdown

0

ups.delay.start

2

ups.load

3.0

ups.mfr


ups.model

Pro 1400 4.01p

ups.serial

unknown

ups.status

OL

ups.temperature

43.0