NAME
oneac - Driver for Oneac UPS equipment
NOTE ABOUT HISTORIC NUT RELEASE
Note
|
Two NUT websites
This version of the page reflects NUT release v2.8.1 with codebase commited 4ba352d8f at 2023-10-31T21:46:20+01:00 Options, features and capabilities in current development (and future releases) are detailed on the main site and may differ from ones described here. |
NOTE
This man page only documents the hardware-specific features of the oneac driver. For information about the core driver, see nutupsdrv(8).
SUPPORTED HARDWARE
This driver supports various Oneac UPS families:
-
EG (late 80s, early 90s, plug-in serial interface card)
-
ON (early and mid-90s, plug-in serial interface card)
-
OZ (mid-90s on, DB-25 std., interface slot)
-
OB (early 2000’s on, big cabinet, DB-25 std., interface slot)
If your UPS is equipped with the Basic Interface card, use the genericups(8) driver.
EXTRA ARGUMENTS
This driver supports the following optional settings in the ups.conf(5) file:
- testtime=num
-
Change battery test time from the 2 minute default.
- offdelay=num
-
Change shutdown delay time from 0 second default.
INSTANT COMMANDS
This driver supports the following Instant Commands. (See upscmd(8))
All UPS units
- shutdown.return
-
Turn off the load possibly after a delay and return when power is back.
- shutdown.stop
-
Stop a shutdown in progress.
- shutdown.reboot
-
Shut down the load briefly while rebooting the UPS.
- test.failure.start
-
Starts a 15 second long simulation of an input power failure.
- test.battery.start.quick
-
Start a "quick" battery test. The default time is 2 minutes. This time can be set in the ups.conf file. See testime above.
- test.battery.stop
-
Stops a battery test that is in progress.
All ON UPS units
- reset.input.minmax
-
Reset the minimum and maximum input line voltage values seen since the last reset or power on.
Newer ON UPS units
- test.panel.start
-
Start testing the UPS panel.
- test.battery.start.deep
-
Start a "deep" battery test. This test runs the UPS until the low battery point and then returns to the AC line.
- reset.input.minmax
-
Reset the minimum and maximum input line voltage values seen since the last reset or power on.
- beeper.enable
-
Enable UPS beeper/buzzer.
- beeper.disable
-
Disable UPS beeper/buzzer.
- beeper.mute
-
Mutes the UPS beeper/buzzer for the current alarm condition(s).
Writable Variables
See upsrw(8) to see what variables are writable for the UPS.
Note
|
If your UPS supports writing battery.runtime.low, the new set value is to be entered in minutes (up to 99) but the reported value is reported in seconds (set value * 60). |
Note
|
If your UPS supports input.transfer.low and input.transfer.high, those values are used to create an allowable output range. The UPS will do what it can to keep the output voltage value within the defined range (for example: tap change or switch to inverter). |
AUTHORS
-
Bill Elliot <bill@wreassoc.com>
-
Eric Lawson <elawson@inficad.com>
SEE ALSO
The core driver:
Internet resources:
The NUT (Network UPS Tools) home page: https://www.networkupstools.org/