Network UPS Tools
Power Devices support
Table of Contents

Click here to see reports of other supported models from Best Power.

Note

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.7.4

Report #1 with driver nutdrv_qx

This device is known to work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

Known supported variables

This device is known to support the following variables (values are just examples):

battery.charge

100

battery.runtime

6180

battery.voltage

13.80

battery.voltage.high

13.6

battery.voltage.low

10.8

device.mfr

Best Power

device.model

Patriot Pro II

device.type

ups

driver.name

nutdrv_qx

driver.parameter.pollfreq

30

driver.parameter.pollinterval

2

driver.parameter.port

/dev/ttyUSB0

driver.parameter.protocol

bestups

driver.parameter.synchronous

no

driver.version

2.7.4

driver.version.data

BestUPS 0.06

driver.version.internal

0.29

input.frequency

60.0

input.transfer.boost.high

109

input.transfer.boost.low

96

input.transfer.high

146

input.transfer.low

96

input.transfer.trim.high

146

input.transfer.trim.low

130

input.voltage

119.0

input.voltage.fault

119.0

this value is reset on the next polling cycle

input.voltage.nominal

120

output.voltage

119.0

output.voltage.nominal

120

ups.delay.shutdown

30

This variable can be set through upsrw within the following ranges:

  • 12..5940

ups.delay.start

180

This variable can be set through upsrw within the following ranges:

  • 60..599940

ups.load

6

ups.power.nominal

400

ups.status

OL

shows CAL during battery test, but does not report RB when front panel LEDs indicate a weak battery.

ups.type

offline / line interactive

Known supported commands

This device is known to support the following NUT’s instant commands:

  • load.off

    when on line power, this is equivalent to shutdown.return.

  • load.on

  • shutdown.return

  • shutdown.stayoff

  • shutdown.stop

  • test.battery.start

  • test.battery.start.deep

  • test.battery.start.quick

  • test.battery.stop

2.2.0

Report #1 with driver bestups (detailed comments available)

This device is known to work with driver bestups. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

Some more detailed comments are available after the "Known supported…" sections.

Known supported variables

This device is known to support the following variables (values are just examples):

battery.charge

100.0

battery.voltage

13.7

battery.voltage.nominal

13.6

driver.name

bestups

driver.parameter.pollinterval

2

driver.parameter.port

/dev/ttyS0

driver.version

2.2.0-1023:1024

driver.version.internal

1.03

input.frequency

60.0

input.voltage

120.9

output.voltage

120.9

ups.load

000

ups.mfr

Best Power

ups.model

Patriot Pro II 400

ups.status

OL

ups.temperature

XX.X