Click here to see reports of other supported models from Eaton.
When a user reports that a variable/command is not right then it will be highlighted by a red underline. Bad values/ranges/etc… will get a red dashed outline or red solid left border. The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left. |
2.7.2
Report #1 with driver usbhid-ups (detailed comments available)
This device is known to work with driver usbhid-ups.
You can grab a dummy-ups compliant .dev
file to simulate this device clicking here.
Some more detailed comments are available after the "Known supported…" sections.
Known supported variables
This device is known to support the following variables (values are just examples):
battery.charge
|
|
battery.charge.low
|
|
battery.runtime
|
|
battery.type
|
|
device.mfr
|
|
device.model
|
|
device.serial
|
Masked by the user. |
device.type
|
|
driver.name
|
|
driver.parameter.pollfreq
|
|
driver.parameter.pollinterval
|
|
driver.parameter.port
|
not needed; "auto" should work |
driver.version
|
|
driver.version.data
|
|
driver.version.internal
|
|
input.frequency
|
|
input.transfer.high
|
|
input.transfer.low
|
|
input.voltage
|
|
input.voltage.extended
|
|
outlet.1.desc
|
|
outlet.1.id
|
|
outlet.1.status
|
|
outlet.1.switchable
|
|
outlet.2.desc
|
|
outlet.2.id
|
|
outlet.2.status
|
|
outlet.2.switchable
|
|
outlet.desc
|
|
outlet.id
|
|
outlet.switchable
|
|
output.frequency
|
|
output.frequency.nominal
|
|
output.voltage
|
|
output.voltage.nominal
|
|
ups.beeper.status
|
|
ups.delay.shutdown
|
|
ups.delay.start
|
|
ups.firmware
|
|
ups.load
|
|
ups.mfr
|
|
ups.model
|
|
ups.power
|
|
ups.power.nominal
|
|
ups.productid
|
|
ups.realpower
|
|
ups.serial
|
Masked by the user. |
ups.status
|
|
ups.timer.shutdown
|
|
ups.timer.start
|
|
ups.vendorid
|
|
Known supported commands
This device is known to support the following NUT’s instant commands:
-
beeper.disable
-
beeper.enable
-
beeper.mute
-
beeper.off
-
beeper.on
-
load.off
-
load.off.delay
-
load.on
-
load.on.delay
-
shutdown.return
-
shutdown.stayoff
-
shutdown.stop
2.0.5
Report #1 with driver hidups (detailed comments available)
This device is known to work with driver hidups, now replaced by the usbhid-ups one.
You can grab a dummy-ups compliant .dev
file to simulate this device clicking here.
Some more detailed comments are available after the "Known supported…" sections.
Known supported variables
This device is known to support the following variables (values are just examples):
battery.charge
|
|
battery.chemistry
|
|
battery.runtime
|
|
battery.voltage
|
|
driver.name
|
|
driver.parameter.lowbatt_pct
|
|
driver.version
|
|
ups.mfr
|
|
ups.model
|
|
ups.serial
|
Masked by the user. |
ups.status
|
|