Network UPS Tools
Power Devices support
Table of Contents

Click here to see reports of other supported models from Energy Technologies.

Note

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.7.4

Report #1 with driver blazer_ser (detailed comments available)

This device is known to work with driver blazer_ser. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

Some more detailed comments are available after the "Known supported…" sections.

Known supported variables

This device is known to support the following variables (values are just examples):

battery.charge

100

battery.voltage

109.44

battery.voltage.high

104.00

battery.voltage.low

83.20

battery.voltage.nominal

96.0

device.mfr

EnergTechnology

device.model

DPK1/1-3

device.type

ups

driver.name

blazer_ser

driver.parameter.offdelay

60

driver.parameter.ondelay

1

driver.parameter.pollinterval

2

driver.parameter.port

/dev/ttyS0

driver.parameter.synchronous

no

driver.version

2.7.4

driver.version.internal

1.57

input.current.nominal

13.0

input.frequency

50.0

input.frequency.nominal

50

input.voltage

229.3

input.voltage.fault

229.3

input.voltage.nominal

220

output.voltage

221.0

ups.beeper.status

disabled

ups.delay.shutdown

60

ups.delay.start

60

ups.firmware

5.11.1

ups.load

39

ups.mfr

EnergTechnology

ups.model

DPK1/1-3

ups.status

OL

ups.temperature

37.5

ups.type

online

About this device

EnergTechnology DPK1/1-3 aka Energy Technologies DPK1/1-3

Shutdown sequence works, including shutdown of the UPS itself, and automatically powering up after AC back.

upsrw gives no output.

Reported at:

Vendor/Manufacturer information:

Further system data or configuration examples:

Driver configuration
[dpk]
 driver = blazer_ser
 port = /dev/ttyS0
 desc = "DPK-1/1-3"
 offdelay = 60
 ondelay = 1
Logs of NUT service startup
:; upsdrvctl start
Network UPS Tools - UPS driver controller 2.7.4
Network UPS Tools - Megatec/Q1 protocol serial driver 1.57 (2.7.4)
Supported UPS detected with megatec protocol
Vendor information read in 1 tries
No values provided for battery high/low voltages in ups.conf
Using 'guestimation' (low: 83.200000, high: 104.000000)!
Battery runtime will not be calculated (runtimecal not set)
Commands per upscmd -l dpk@localhost listing
# TODO: Convert to CMD:... markup
:; upscmd -l dpk@localhost
Instant commands supported on UPS [dpk]:
beeper.toggle - Toggle the UPS beeper
load.off - Turn off the load immediately
load.on - Turn on the load immediately
shutdown.return - Turn off the load and return when power is back
shutdown.stayoff - Turn off the load and remain off
shutdown.stop - Stop a shutdown in progress
test.battery.start - Start a battery test
test.battery.start.deep - Start a deep battery test
test.battery.start.quick - Start a quick battery test
test.battery.stop - Stop the battery test