Network UPS Tools
Power Devices support
Table of Contents

Click here to see reports of other supported models from PowerWalker.

Note

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.7.4

Report #1 with driver blazer_usb

This device is known to work with driver blazer_usb. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

Known supported variables

This device is known to support the following variables (values are just examples):

battery.charge

100

battery.voltage

13.40

battery.voltage.high

13.00

battery.voltage.low

10.40

battery.voltage.nominal

12.0

device.type

ups

driver.name

blazer_usb

driver.parameter.pollinterval

2

driver.parameter.port

auto

driver.parameter.synchronous

no

driver.version

2.7.4

driver.version.internal

0.12

input.current.nominal

2.0

input.frequency

50.1

input.frequency.nominal

50

input.voltage

235.0

input.voltage.fault

235.0

input.voltage.nominal

230

output.voltage

235.0

ups.beeper.status

enabled

ups.delay.shutdown

30

ups.delay.start

180

ups.load

0

ups.productid

5161

ups.status

OL

ups.type

offline / line interactive

ups.vendorid

0665