Network UPS Tools
Power Devices support
Table of Contents

Click here to see reports of other supported models from Salicru.

Note

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.8.0

Report #1 with driver usbhid_ups (detailed comments available)

This device is known to work with driver usbhid_ups.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

Some more detailed comments are available after the "Known supported…" sections.

Known supported variables

This device is known to support the following variables (values are just examples):

battery.charge

100

battery.charge.low

10

battery.charge.warning

20

battery.runtime

4500

battery.runtime.low

300

battery.type

PbAcid

battery.voltage

26.00

battery.voltage.nominal

24

device.mfr

1

device.model

850

device.serial

000000000000

device.type

ups

driver.name

usbhid-ups

driver.parameter.pollfreq

30

driver.parameter.pollinterval

2

driver.parameter.port

auto

driver.parameter.productid

0302

driver.parameter.synchronous

auto

driver.parameter.vendorid

2e66

driver.version

2.8.0-21-gf8462e88a

driver.version.data

Salicru HID 0.3

driver.version.internal

0.47

driver.version.usb

libusb-0.1 (or compat)

input.frequency

50.2

input.voltage

228.0

input.voltage.nominal

230

output.frequency

50.2

output.voltage

22.8

output.voltage.nominal

24

ups.beeper.status

enabled

ups.load

11

ups.mfr

1

ups.model

850

ups.productid

0302

ups.realpower.nominal

595

ups.serial

000000000000

ups.status

OL

ups.vendorid

2e66

About this device

First report for new salicru HID subdriver from PR referenced above for Salicru SPS 850 ADV T.

Note I tried to set the value of battery.runtime.low and battery.charge.low using upsrw, but although the command returns OK, no values seem to be modified.

Reported at:

Vendor/Manufacturer information:

Further system data or configuration examples:

Variables per upsrw ups@localhost listing
# TODO: Convert to RW:... and RO:... markup
:; upsrw ups@localhost
[battery.charge.low]
Remaining battery level when UPS switches to LB (percent)
Type: STRING
Maximum length: 10
Value: 10

[battery.runtime.low]
Remaining battery runtime when UPS switches to LB (seconds)
Type: STRING
Maximum length: 10
Value: 300
Commands per upscmd -l ups@localhost listing
# Commands (none reported)
# TODO: Convert to CMD:... markup
:; upscmd -l ups@localhost
Instant commands supported on UPS [salicru]: