Network UPS Tools
Power Devices support
Table of Contents

Click here to see reports of other supported models from Salicru.

Note

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.7.2

Report #1 with driver nutdrv_qx (detailed comments available)

This device is known to work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

Some more detailed comments are available after the "Known supported…" sections.

Known supported variables

This device is known to support the following variables (values are just examples):

battery.charge

70

battery.voltage

24.30

battery.voltage.high

25.50

battery.voltage.low

21.50

battery.voltage.nominal

24.0

device.type

ups

driver.name

nutdrv_qx

driver.parameter.offdelay

120

driver.parameter.ondelay

120

driver.parameter.pollfreq

30

driver.parameter.pollinterval

2

driver.parameter.port

auto

driver.version

2.7.2

driver.version.data

Voltronic-QS 0.01

driver.version.internal

0.06

input.current.nominal

8.0

input.frequency

50.1

input.frequency.nominal

50

input.voltage

229.7

input.voltage.fault

229.7

input.voltage.nominal

230

output.voltage

229.7

ups.beeper.status

enabled

ups.delay.shutdown

120

ups.delay.start

120

ups.firmware.aux

PMV

ups.load

6

ups.productid

5161

ups.status

OL

ups.type

offline / line interactive

ups.vendorid

0665

About this device

Reported at:

Vendor/Manufacturer information:

Further system data or configuration examples:

Variables per upsrw salicru@localhost listing
# TODO: Convert to RW:... and RO:... markup
:; upsrw salicru@localhost
[ups.delay.shutdown]
Interval to wait after shutdown with delay command (seconds)
Type: RANGE
Option: "12-540" SELECTED

[ups.delay.start]
Interval to wait before (re)starting the load (seconds)
Type: RANGE
Option: "60-599940" SELECTED
Commands per upscmd -l salicru@localhost listing
# TODO: Convert to CMD:... markup
:; upscmd -l salicru@localhost
Instant commands supported on UPS [salicru]:
beeper.toggle - Toggle the UPS beeper
load.off - Turn off the load immediately
load.on - Turn on the load immediately
shutdown.return - Turn off the load and return when power is back
shutdown.stayoff - Turn off the load and remain off
shutdown.stop - Stop a shutdown in progress
test.battery.start.quick - Start a quick battery test
Logs of shutdown with LOWBATT
Shutdown worked as expected when reaching LOWBATT:
  May 13 20:43:22 oriolnas upsmon[1535]: UPS salicru@127.0.0.1 battery is low
  May 13 20:43:22 oriolnas upsd[1532]: Client upsmon@127.0.0.1 set FSD on UPS [salicru]
  May 13 20:43:22 oriolnas upsmon[1535]: Executing automatic power-fail shutdown
  May 13 20:43:22 oriolnas upsmon[1535]: Auto logout and shutdown proceeding