Click here to see reports of other supported models from Tripp Lite.
When a user reports that a variable/command is not right then it will be highlighted by a red underline. Bad values/ranges/etc… will get a red dashed outline or red solid left border. The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left. |
2.7.4.1
Report #1 with driver tripplite_usb (detailed comments available)
This device is known to work with driver tripplite_usb.
You can grab a dummy-ups compliant .dev
file to simulate this device clicking here.
Some more detailed comments are available after the "Known supported…" sections.
Known supported variables
This device is known to support the following variables (values are just examples):
battery.charge
|
|
battery.voltage
|
|
battery.voltage.nominal
|
|
device.mfr
|
|
device.model
|
|
device.type
|
|
driver.name
|
|
driver.parameter.pollinterval
|
|
driver.parameter.port
|
|
driver.parameter.synchronous
|
|
driver.version
|
|
driver.version.internal
|
|
input.voltage
|
|
input.voltage.maximum
|
|
input.voltage.minimum
|
|
input.voltage.nominal
|
|
outlet.1.desc
|
|
outlet.1.id
|
|
outlet.1.switch
|
|
outlet.1.switchable
|
|
outlet.2.desc
|
|
outlet.2.id
|
|
outlet.2.switchable
|
|
ups.debug.D
|
|
ups.debug.L
|
|
ups.debug.M
|
|
ups.debug.P
|
|
ups.debug.S
|
|
ups.debug.T
|
|
ups.debug.V
|
|
ups.debug.load_banks
|
|
ups.delay.shutdown
|
|
ups.firmware
|
|
ups.firmware.aux
|
|
ups.id
|
|
ups.mfr
|
|
ups.model
|
|
ups.power.nominal
|
|
ups.productid
|
|
ups.status
|
|
ups.temperature
|
|
ups.vendorid
|
|
About this device
Shutdown sequence is a work in progress, but without battery.charge
there is no low battery. And the jumping battery voltage levels when
the charge gets lower aren’t helping either.
Reported at:
Further system data or configuration example:
upsrw ups@localhost
listing# TODO: Convert to RW:... and RO:... markup
:; upsrw ups@localhost
[outlet.1.switch]
Outlet switch control
Type: STRING
Maximum length: 3
Value: 1
[ups.delay.shutdown]
Interval to wait after shutdown with delay command (seconds)
Type: STRING
Maximum length: 3
Value: 64
[ups.id]
UPS system identifier
Type: STRING
Maximum length: 5
Value: 0