H. Configure options

Note

For more information about build environment setup, see chapters below about Configuration prerequisites and CI Farm configuration notes.

Two NUT websites

This version of the page reflects NUT release v2.8.2 with codebase commited 440ca2348 at 2024-04-01T22:07:23+02:00

Options, features and capabilities in current development (and future releases) are detailed on the main site and may differ from ones described here.

Note

When building NUT from Git sources rather than the distribution tarballs, you would have to generate the configure script and some further needed files by running ./autogen.sh. This in turn may require additional tools and other dependencies on your build environment (referenced just a bit below). For common developer iterations, porting to new platforms, or in-place testing, running the ./ci_build.sh script can be a helpful one-stop solution.

+ The NUT Packager Guide, which presents the best practices for installing and integrating NUT, is also a good reading.

+ The Prerequisites for building NUT on different OSes document suggests prerequisite packages with tools and dependencies available and needed to build and test as much as possible of NUT on numerous platforms, written from perspective of CI testing (if you are interested in getting updated drivers for a particular device, you might select a sub-set of those suggestions).

There are a few options reviewed below that can be given to configure script to tweak your compilations. See also ./configure --help for a current and complete listing for the current version of the codebase.

NUT tracks configure options used during build, so you can view them to produce a replacement by asking NUT programs for --help or for --version with debugging enabled (first), e.g.:

:; upsd -DV
Network UPS Tools upsd 2.8.1
Network UPS Tools version 2.8.1 configured with flags: --with-all=auto --with-doc=skip ...

A more industrial approach is to use lib/libupsclient-config --config-flags where supported.