Network UPS Tools - Aviem Pro 2000VA

Click here to see reports of other supported models from Aviem Systems.

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.7.4

Report #1 with driver blazer_usb (detailed comments available)

This device is known to work with driver blazer_usb. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

Some more detailed comments are available after the "Known supported…" sections.

Known supported variables

This device is known to support the following variables (values are just examples):

battery.charge	`100`
battery.voltage	`27.70`
battery.voltage.high	`26.00`
battery.voltage.low	`20.80`
battery.voltage.nominal	`24.0`
device.type	`ups`
driver.name	`blazer_usb`
driver.parameter.offdelay	`120`
driver.parameter.ondelay	`240`
driver.parameter.pollinterval	`2`
driver.parameter.port	`auto`
driver.parameter.synchronous	`no`
driver.version	`2.7.4`
driver.version.internal	`0.12`
input.current.nominal	`9.0`
input.frequency	`49.6`
input.frequency.nominal	`50`
input.voltage	`230.8`
input.voltage.fault	`231.3`
input.voltage.nominal	`220`
output.voltage	`231.3`
ups.beeper.status	`enabled`
ups.delay.shutdown	`120`
ups.delay.start	`14400`
ups.load	`10`
ups.productid	`5161`
ups.status	`OL`
ups.type	`offline / line interactive`
ups.vendorid	`0665`

About this device

Manufacturer: Aviem Systems
Model: Aviem Pro 2000VA

Reported at:

https://github.com/networkupstools/nut/issues/827

Further system data or configuration examples:

Driver configuration

[aviem]
        driver = blazer_usb
        port = auto
        desc = "ServerUPS"
        offdelay = 120
        ondelay = 240

Syslog of NUT startup

:; cat /var/log/syslog | grep upsd
upsdrvctl: Network UPS Tools - UPS driver controller 2.7.4
upsdrvctl: Supported UPS detected with megatec protocol
upsdrvctl: Vendor information unavailable
upsdrvctl: No values provided for battery high/low voltages in ups.conf
upsdrvctl: Using 'guestimation' (low: 20.800000, high: 26.000000)!
upsdrvctl: Battery runtime will not be calculated (runtimecal not set)
upsdrvctl: Network UPS Tools - UPS driver controller 2.7.4
upsd: fopen /var/run/nut/upsd.pid: No such file or directory
upsd: listening on ::1 port 3493
upsd: listening on ::1 port 3493
upsd: listening on 127.0.0.1 port 3493
upsd: listening on 127.0.0.1 port 3493
upsd: Connected to UPS [apc]: blazer_usb-apc
upsd: Connected to UPS [apc]: blazer_usb-apc
upsd: Startup successful

lsusb listing

:; lsusb -vvv
Bus 001 Device 003: ID 0665:5161 Cypress Semiconductor USB to Serial
Device Descriptor:
  bLength                18
  bDescriptorType         1
  bcdUSB               1.10
  bDeviceClass            0
  bDeviceSubClass         0
  bDeviceProtocol         0
  bMaxPacketSize0         8
  idVendor           0x0665 Cypress Semiconductor
  idProduct          0x5161 USB to Serial
  bcdDevice            0.02
  iManufacturer           1 INNO TECH
  iProduct                2 USB to Serial
  iSerial                 3 20100826
  bNumConfigurations      1
  Configuration Descriptor:
    bLength                 9
    bDescriptorType         2
    wTotalLength       0x0022
    bNumInterfaces          1
    bConfigurationValue     1
    iConfiguration          3 20100826
    bmAttributes         0x80
      (Bus Powered)
    MaxPower              100mA
    Interface Descriptor:
      bLength                 9
      bDescriptorType         4
      bInterfaceNumber        0
      bAlternateSetting       0
      bNumEndpoints           1
      bInterfaceClass         3 Human Interface Device
      bInterfaceSubClass      0
      bInterfaceProtocol      0
      iInterface              4 Sample HID
        HID Device Descriptor:
          bLength                 9
          bDescriptorType        33
          bcdHID               1.00
          bCountryCode            0 Not supported
          bNumDescriptors         1
          bDescriptorType        34 Report
          wDescriptorLength      27
         Report Descriptors:
           ** UNAVAILABLE **
      Endpoint Descriptor:
        bLength                 7
        bDescriptorType         5
        bEndpointAddress     0x81  EP 1 IN
        bmAttributes            3
          Transfer Type            Interrupt
          Synch Type               None
          Usage Type               Data
        wMaxPacketSize     0x0008  1x 8 bytes
        bInterval              32