Network UPS Tools - E Series DX UPS 1-20 kVA

Click here to see reports of other supported models from Eaton.

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.7.3

This device is known to work with driver blazer_ser. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

This device is known to support the following variables (values are just examples):

battery.charge	`100`
battery.voltage	`109.44`
battery.voltage.high	`104.00`
battery.voltage.low	`83.20`
battery.voltage.nominal	`96.0`
device.type	`ups`
driver.name	`blazer_ser`
driver.parameter.pollinterval	`10`
driver.parameter.port	`/dev/ttyS0`
driver.parameter.synchronous	`no`
driver.version	`2.7.3` shutdown supported from v2.7.1 on
driver.version.internal	`1.56`
input.current.nominal	`10.0`
input.frequency	`50.0`
input.frequency.nominal	`50`
input.voltage	`236.3`
input.voltage.fault	`215.4`
input.voltage.nominal	`220`
output.voltage	`221.0`
ups.beeper.status	`enabled`
ups.delay.shutdown	`60` offdelay must be greater than or equal to 60 seconds. Reference: https://github.com/networkupstools/nut/issues/238
ups.delay.start	`180`
ups.load	`4`
ups.status	`OL`
ups.temperature	`25.0`
ups.type	`online`

This device is known to support the following NUT’s instant commands: