Network UPS Tools - Mars Convertible 3000 MS3000RT

Click here to see reports of other supported models from Ablerex.

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.2.0

This device is known to work with driver megatec, now replaced by the blazer_ser one. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

This device is known to support the following variables (values are just examples):

battery.charge	`100.0`
battery.voltage	`2.29`
battery.voltage.nominal	`96.0`
driver.name	`megatec`
driver.parameter.pollinterval	`2`
driver.parameter.port	`/dev/ttyUSB0`
driver.version	`2.2.0-`
driver.version.internal	`1.5.4`
input.frequency	`50.0`
input.voltage	`227.1`
input.voltage.fault	`190.0`
input.voltage.maximum	`230.6`
input.voltage.minimum	`216.5`
output.voltage	`221.3`
output.voltage.nominal	`220.0`
ups.beeper.status	`disabled`
ups.delay.shutdown	`0`
ups.delay.start	`2`
ups.load	`95.0`
ups.mfr	`Ablerex`
ups.model	`MS3000RT MS02035C`
ups.serial	`unknown`
ups.status	`OL`
ups.temperature	`55.8`

This device is known to work with driver megatec, now replaced by the blazer_ser one. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

This device is known to support the following variables (values are just examples):