Network UPS Tools
Power Devices support
Table of Contents

Click here to see reports of other supported models from Eaton.

Note

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.7.3

Report #1

This device is known to work with driver blazer_ser. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

Known supported variables

This device is known to support the following variables (values are just examples):

battery.charge

100

battery.voltage

109.44

battery.voltage.high

104.00

battery.voltage.low

83.20

battery.voltage.nominal

96.0

device.type

ups

driver.name

blazer_ser

driver.parameter.pollinterval

10

driver.parameter.port

/dev/ttyS0

driver.parameter.synchronous

no

driver.version

2.7.3

shutdown supported from v2.7.1 on

driver.version.internal

1.56

input.current.nominal

10.0

input.frequency

50.0

input.frequency.nominal

50

input.voltage

236.3

input.voltage.fault

215.4

input.voltage.nominal

220

output.voltage

221.0

ups.beeper.status

enabled

ups.delay.shutdown

60

offdelay must be greater than or equal to 60 seconds. Reference: https://github.com/networkupstools/nut/issues/238

ups.delay.start

180

ups.load

4

ups.status

OL

ups.temperature

25.0

ups.type

online

Known supported commands

This device is known to support the following NUT’s instant commands:

  • beeper.toggle

  • load.off

  • load.on

  • shutdown.return

  • shutdown.stayoff

  • shutdown.stop

  • test.battery.start

  • test.battery.start.deep

  • test.battery.start.quick

  • test.battery.stop