Network UPS Tools
Power Devices support
Table of Contents

Click here to see reports of other supported models from Mustek.

Note

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.4.1

Report #1

This device is known to work with driver megatec, now replaced by the blazer_ser one. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

Known supported variables

This device is known to support the following variables (values are just examples):

battery.voltage

108.00

battery.voltage.nominal

96.0

driver.name

megatec

driver.parameter.pollinterval

2

driver.parameter.port

/dev/cuad0

driver.version

2.4.1

driver.version.internal

1.6

input.frequency

50.0

input.frequency.nominal

50.0

input.voltage

227.0

input.voltage.fault

227.0

input.voltage.maximum

228.8

input.voltage.minimum

224.1

input.voltage.nominal

220.0

output.voltage

227.0

ups.beeper.status

enabled

ups.delay.shutdown

0

ups.delay.start

2

ups.load

30.0

ups.mfr

unknown

ups.model

unknown

ups.serial

unknown

ups.status

OL

ups.temperature

60.6

ups.type

standby