Network UPS Tools - Powermust 1000VA USB

Click here to see reports of other supported models from Mustek.

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.6.4

This device is known to work with driver blazer_usb. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

This device is known to support the following variables (values are just examples):

battery.charge	`100`
battery.voltage	`27.40`
battery.voltage.high	`26.00`
battery.voltage.low	`20.80`
battery.voltage.nominal	`24.0`
device.type	`ups`
driver.name	`blazer_usb`
driver.parameter.pollinterval	`2`
driver.parameter.port	`auto`
driver.version	`2.6.4`
driver.version.internal	`0.08`
input.current.nominal	`4.0`
input.frequency	`50.0`
input.frequency.nominal	`50`
input.voltage	`228.1`
input.voltage.fault	`228.6`
input.voltage.nominal	`220`
output.voltage	`229.5`
ups.beeper.status	`enabled`
ups.delay.shutdown	`30`
ups.delay.start	`180`
ups.load	`7`
ups.productid	`5161`
ups.status	`OL`
ups.temperature	`25.0`
ups.type	`offline / line interactive`
ups.vendorid	`0665`

This device is known to support the following NUT’s instant commands:

This device is known to work with driver megatec, now replaced by the blazer_ser one. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

This device is known to support the following variables (values are just examples):

battery.charge	`100.0`
battery.voltage	`27.60`
battery.voltage.nominal	`24.0`
driver.name	`megatec`
driver.parameter.pollinterval	`2`
driver.parameter.port	`/dev/ttyS0`
driver.version	`2.2.0-exporté`
driver.version.internal	`1.5.4`
input.frequency	`50.1`
input.voltage	`230.5`
input.voltage.fault	`230.5`
input.voltage.maximum	`232.5`
input.voltage.minimum	`217.1`
output.voltage	`224.0`
output.voltage.nominal	`220.0`
ups.beeper.status	`enabled`
ups.delay.shutdown	`0`
ups.delay.start	`2`
ups.load	`14.0`
ups.mfr	`unknown`
ups.model	`unknown`
ups.serial	`unknown`
ups.status	`OL`
ups.temperature	`25.0`