Network UPS Tools - Yunto YQ450

Click here to see reports of other supported models from Online.

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.6.3

This device is known to work with driver blazer_usb. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

This device is known to support the following variables (values are just examples):

battery.voltage	`13.40`
beeper.status	`disabled`
device.type	`ups`
driver.name	`blazer_usb`
driver.parameter.pollinterval	`2`
driver.parameter.port	`auto`
driver.parameter.productid	`0002`
driver.parameter.protocol	`zinto`
driver.parameter.subdriver	`cypress`
driver.parameter.vendorid	`06da`
driver.version	`2.6.3`
driver.version.internal	`0.04`
input.frequency	`50.0`
input.voltage	`232.0`
input.voltage.fault	`1.0`
output.voltage	`232.0`
ups.delay.shutdown	`30`
ups.delay.start	`180`
ups.load	`0`
ups.productid	`0002`
ups.status	`OL BYPASS`
ups.temperature	`25.0` Temperature is always `25.0` (°C).
ups.type	`offline / line interactive`
ups.vendorid	`06da`

This device is known to work with driver megatec_usb, now replaced by the blazer_usb one. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

This device is known to support the following variables (values are just examples):

battery.voltage	`13.30`
driver.name	`megatec_usb`
driver.parameter.pollinterval	`2`
driver.parameter.port	`auto`
driver.version	`2.3.0`
driver.version.internal	`1.5.14`
input.frequency	`49.9`
input.voltage	`229.0`
input.voltage.fault	`0.0`
input.voltage.maximum	`235.0`
input.voltage.minimum	`228.0`
output.voltage	`228.0`
ups.beeper.status	`disabled`
ups.delay.shutdown	`0`
ups.delay.start	`2`
ups.load	`45.0`
ups.mfr	`unknown`
ups.model	`unknown`
ups.serial	`unknown`
ups.status	`OL TRIM`
ups.temperature	`25.0`
ups.type	`standby`