Network UPS Tools

Click here to see reports of other supported models from Plexus.

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.2.1

This device is known to work with driver megatec_usb, now replaced by the blazer_usb one. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

This device is known to support the following variables (values are just examples):

battery.charge	`89.8`
battery.voltage	`11.50`
battery.voltage.nominal	`11.5`
driver.name	`megatec_usb`
driver.parameter.battvolts	`0.0:12.8`
driver.parameter.mfr	`Plexus`
driver.parameter.model	`500VA`
driver.parameter.pollinterval	`2`
driver.parameter.port	`/dev/usb/hiddev0`
driver.parameter.vendorid	`0001`
driver.version	`2.2.1-`
driver.version.internal	`1.5.9`
input.frequency	`50.0`
input.voltage	`0.0`
input.voltage.fault	`165.0`
output.voltage	`230.0`
output.voltage.nominal	`230.0`
ups.beeper.status	`disabled`
ups.delay.shutdown	`0`
ups.delay.start	`2`
ups.load	`100.0`
ups.mfr	`Plexus`
ups.model	`500VA`
ups.serial	`unknown`
ups.status	`OB`
ups.temperature	`0.0`

This device is known to support the following NUT’s instant commands: