Network UPS Tools - Line-Interactive VI 1400

Click here to see reports of other supported models from PowerWalker.

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.4.3

This device is known to work with driver blazer_usb. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

This device is known to support the following variables (values are just examples):

battery.voltage	`25.70`
battery.voltage.nominal	`24.0`
beeper.status	`enabled`
device.type	`ups`
driver.name	`blazer_usb`
driver.parameter.offdelay	`60`
driver.parameter.ondelay	`5`
driver.parameter.pollinterval	`2`
driver.parameter.port	`auto`
driver.parameter.productid	`5161`
driver.parameter.vendorid	`0665`
driver.version	`2.4.3`
driver.version.internal	`0.03`
input.current.nominal	`2.0`
input.frequency	`50.1`
input.frequency.nominal	`50`
input.voltage	`224.3`
input.voltage.fault	`224.3`
input.voltage.nominal	`230`
output.voltage	`219.5`
ups.delay.shutdown	`60`
ups.delay.start	`300`
ups.load	`11`
ups.productid	`5161`
ups.status	`OL`
ups.temperature	`25.0`
ups.type	`offline / line interactive`
ups.vendorid	`0665`

This device is known to work with driver megatec, now replaced by the blazer_ser one. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

This device is known to support the following variables (values are just examples):