Network UPS Tools
Power Devices support
Table of Contents

Click here to see reports of other supported models from PowerWalker.

Note

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.6.0

Report #1

This device is known to work with driver blazer_usb. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

Known supported variables

This device is known to support the following variables (values are just examples):

battery.charge

100

battery.voltage

13.50

battery.voltage.high

13.5

battery.voltage.low

10

battery.voltage.nominal

12.0

beeper.status

enabled

device.type

ups

driver.name

blazer_usb

driver.parameter.pollinterval

2

driver.parameter.port

auto

driver.version

2.6.0

driver.version.internal

0.03

input.current.nominal

3.0

input.frequency

50.1

input.frequency.nominal

50

input.voltage

228.2

input.voltage.fault

228.2

input.voltage.nominal

220

output.voltage

228.2

ups.delay.shutdown

30

ups.delay.start

180

ups.load

63

ups.productid

5161

ups.status

OL

ups.type

offline / line interactive

ups.vendorid

0665

Known supported commands

This device is known to support the following NUT’s instant commands:

  • load.off

  • load.on

  • shutdown.return

  • shutdown.stayoff

  • shutdown.stop

  • test.battery.start

  • test.battery.start.deep

  • test.battery.start.quick

  • test.battery.stop