Network UPS Tools
Power Devices support
Table of Contents

Click here to see reports of other supported models from Rucelf.

Note

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.7.2

Report #1

This device is known to work with driver blazer_ser. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

Known supported variables

This device is known to support the following variables (values are just examples):

battery.charge

100

battery.voltage

108.48

battery.voltage.high

104.00

battery.voltage.low

83.20

battery.voltage.nominal

96.0

device.mfr


device.model


device.type

ups

driver.name

blazer_ser

driver.parameter.pollinterval

2

driver.parameter.port

/dev/cuaU0

driver.version

2.7.2

driver.version.internal

1.56

input.current.nominal

9.0

input.frequency

49.9

input.frequency.nominal

50

input.voltage

212.5

input.voltage.fault

220.0

input.voltage.nominal

220

output.voltage

220.3

ups.beeper.status

enabled

ups.delay.shutdown

30

ups.delay.start

180

ups.firmware

R35.00

ups.load

35

ups.mfr


ups.model


ups.status

OL

ups.temperature

33.6

ups.type

online

Known supported commands

This device is known to support the following NUT’s instant commands:

  • beeper.toggle

  • load.off

  • load.on

  • shutdown.return

  • shutdown.stayoff

  • shutdown.stop

  • test.battery.start

  • test.battery.start.deep

  • test.battery.start.quick

  • test.battery.stop