Network UPS Tools - ULT33046 2000 VA 1200 W Backup UPS with AVR B000GC98H8

Click here to see reports of other supported models from Ultra.

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.4.1

This device is known to work with driver powercom.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

This device is known to support the following variables (values are just examples):

battery.charge	`0.0`
driver.name	`powercom`
driver.parameter.batteryPercentage	`{5.0000,0.3268,-825.00,0.46511,0}`
driver.parameter.linevoltage	`120`
driver.parameter.loadPercentage	`{1.4474,0.0,0.8594,0.0}`
driver.parameter.manufacturer	`PowerCom`
driver.parameter.methodOfFlowControl	`no_flow_control`
driver.parameter.modelname	`RCD-UPS2000D`
driver.parameter.numOfBytesFromUPS	`16`
driver.parameter.pollinterval	`2`
driver.parameter.port	`/dev/ttyUSB0`
driver.parameter.serialnumber	`40206430906`
driver.parameter.shutdownArguments	`{{1,30},y}`
driver.parameter.type	`BNT-other`
driver.parameter.validationSequence	`{{8,0},{8,0},{8,0}}`
driver.parameter.voltage	`{1.9216,-0.0977,0.82857,0.0000}`
driver.version	`2.4.1`
driver.version.internal	`0.12`
input.frequency	`80.12` This should be `60`.
input.voltage	`100.8` The display on the front panel claims `124` at the moment.
input.voltage.nominal	`120`
output.frequency	`80.12` This should be `60`.
output.voltage	`100.8`
ups.load	`12.9`
ups.mfr	`PowerCom`
ups.model	`KIN-2200AP`
ups.model.type	`KIN`
ups.serial	`40206430906`
ups.status	`OL`

This device is known to work with driver powercom.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

This device is known to support the following variables (values are just examples):

battery.charge	`0.0`
driver.name	`powercom`
driver.parameter.pollinterval	`2`
driver.parameter.port	`/dev/ttyUSB0`
driver.parameter.type	`KIN`
driver.parameter.validationSequence	`{{11,0x4b},{8,0},{8,0}}`
driver.version	`2.4.1`
driver.version.internal	`0.12`
input.frequency	`80.12` This should be `60`.
input.voltage	`100.8` The display on the front panel claims `124` at the moment.
input.voltage.nominal	`120`
output.frequency	`80.12` This should be `60`.
output.voltage	`100.8`
ups.load	`12.9`
ups.mfr	`PowerCom`
ups.model	`KIN-2200AP`
ups.model.type	`KIN`
ups.serial	`Unknown`
ups.status	`OL`