Click here to see reports of other supported models from Best Power.
|
When a user reports that a variable/command is not right then it will be highlighted by a red underline. Bad values/ranges/etc… will get a red dashed outline or red solid left border. The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left. |
2.7.4
Report #1 with driver nutdrv_qx
This device is known to work with driver nutdrv_qx.
You can grab a dummy-ups compliant .dev file to simulate this device clicking here.
Known supported variables
This device is known to support the following variables (values are just examples):
|
battery.charge
|
|
|
battery.runtime
|
|
|
battery.voltage
|
|
|
battery.voltage.high
|
|
|
battery.voltage.low
|
|
|
device.mfr
|
|
|
device.model
|
|
|
device.type
|
|
|
driver.name
|
|
|
driver.parameter.pollfreq
|
|
|
driver.parameter.pollinterval
|
|
|
driver.parameter.port
|
|
|
driver.parameter.protocol
|
|
|
driver.parameter.synchronous
|
|
|
driver.version
|
|
|
driver.version.data
|
|
|
driver.version.internal
|
|
|
input.frequency
|
|
|
input.transfer.boost.high
|
|
|
input.transfer.boost.low
|
|
|
input.transfer.high
|
|
|
input.transfer.low
|
|
|
input.transfer.trim.high
|
|
|
input.transfer.trim.low
|
|
|
input.voltage
|
|
|
input.voltage.fault
|
this value is reset on the next polling cycle |
|
input.voltage.nominal
|
|
|
output.voltage
|
|
|
output.voltage.nominal
|
|
|
ups.delay.shutdown
|
This variable can be set through upsrw within the following ranges:
|
|
ups.delay.start
|
This variable can be set through upsrw within the following ranges:
|
|
ups.load
|
|
|
ups.power.nominal
|
|
|
ups.status
|
shows |
|
ups.type
|
|
Known supported commands
This device is known to support the following NUT’s instant commands:
-
load.off
when on line power, this is equivalent to
shutdown.return. -
load.on
-
shutdown.return
-
shutdown.stayoff
-
shutdown.stop
-
test.battery.start
-
test.battery.start.deep
-
test.battery.start.quick
-
test.battery.stop
2.2.0
Report #1 with driver bestups (detailed comments available)
You can grab a dummy-ups compliant .dev file to simulate this device clicking here.
Some more detailed comments are available after the "Known supported…" sections.
Known supported variables
This device is known to support the following variables (values are just examples):
|
battery.charge
|
|
|
battery.voltage
|
|
|
battery.voltage.nominal
|
|
|
driver.name
|
|
|
driver.parameter.pollinterval
|
|
|
driver.parameter.port
|
|
|
driver.version
|
|
|
driver.version.internal
|
|
|
input.frequency
|
|
|
input.voltage
|
|
|
output.voltage
|
|
|
ups.load
|
|
|
ups.mfr
|
|
|
ups.model
|
|
|
ups.status
|
|
|
ups.temperature
|
|
About this device
Reported at:
