NAME

tripplite - Driver for Tripp-Lite SmartPro UPS equipment

NOTE ABOUT HISTORIC NUT RELEASE

Note
Two NUT websites

This version of the page reflects NUT release v2.8.1 with codebase commited 4ba352d8f at 2023-10-31T21:46:20+01:00

Options, features and capabilities in current development (and future releases) are detailed on the main site and may differ from ones described here.

NOTE

This man page only documents the hardware-specific features of the tripplite driver. For information about the core driver, see nutupsdrv(8).

SUPPORTED HARDWARE

This driver should work on the SmartPro line, including the SMART700 and SMART700SER. It only supports SmartPro models that communicate using the serial port.

EXTRA ARGUMENTS

This driver supports the following optional settings in the ups.conf(5):

offdelay=num

Time to wait before the UPS is turned off after the kill power command is sent. The default value is 64 (in seconds).

rebootdelay=num

Set the timer before the UPS is cycled after the reboot command is sent. The default value is 64 (in seconds).

startdelay=num

Set the time that the UPS waits before it turns itself back on after a reboot command. The default value is 60 (in seconds).

KNOWN ISSUES AND BUGS

Battery charge information may not be correct for all UPSes. It is tuned to be correct for a SMART700SER. Other models may not provide correct information. Information from the manufacturer would be helpful.

AUTHORS

  • Rickard E. (Rik) Faith

  • Nicholas Kain

SEE ALSO

The core driver:

nutupsdrv(8)

Other drivers for Tripp-Lite hardware:

tripplitesu(8), tripplite_usb(8), usbhid-ups(8)

Internet resources:

The NUT (Network UPS Tools) home page: https://www.networkupstools.org/