Click here to see reports of other supported models from APC.
|
When a user reports that a variable/command is not right then it will be highlighted by a red underline. Bad values/ranges/etc… will get a red dashed outline or red solid left border. The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left. |
2.7.4.1
Report #1 with driver usbhid-ups (detailed comments available)
This device is known to work with driver usbhid-ups.
You can grab a dummy-ups compliant .dev file to simulate this device clicking here.
Some more detailed comments are available after the "Known supported…" sections.
Known supported variables
This device is known to support the following variables (values are just examples):
|
battery.charge
|
|
|
battery.charge.low
|
|
|
battery.charge.warning
|
|
|
battery.runtime
|
|
|
battery.runtime.low
|
|
|
battery.type
|
|
|
battery.voltage
|
|
|
battery.voltage.nominal
|
|
|
device.mfr
|
|
|
device.model
|
|
|
device.serial
|
|
|
device.type
|
|
|
driver.name
|
|
|
driver.parameter.pollfreq
|
|
|
driver.parameter.pollinterval
|
|
|
driver.parameter.port
|
|
|
driver.parameter.synchronous
|
|
|
driver.version
|
|
|
driver.version.data
|
|
|
driver.version.internal
|
|
|
ups.beeper.status
|
|
|
ups.delay.shutdown
|
|
|
ups.firmware
|
|
|
ups.mfr
|
|
|
ups.mfr.date
|
|
|
ups.model
|
|
|
ups.productid
|
|
|
ups.serial
|
|
|
ups.status
|
|
|
ups.timer.reboot
|
|
|
ups.timer.shutdown
|
|
|
ups.vendorid
|
|
About this device
This is a new 2017 model targeted to brazilian market. It does have a USB port and a RJ50 serial port which may need a 940-0625A (RJ50 to DB9) cable.
USB pass-through into a VM works.
Some important readings are missing: I was hoping to see
something like input.voltage or ups.load
Missing values are likely due to NUT’s lack of APC-Modbus support: https://github.com/networkupstools/nut/issues/139
Reported at:
Further system data or configuration example:
upscmd -l worldbyte@localhost listing# TODO: Convert to CMD:... markup
:; upscmd -l worldbyte@localhost
Instant commands supported on UPS [worldbyte]:
beeper.disable - Disable the UPS beeper
beeper.enable - Enable the UPS beeper
beeper.mute - Temporarily mute the UPS beeper
beeper.off - Obsolete (use beeper.disable or beeper.mute)
beeper.on - Obsolete (use beeper.enable)
load.off - Turn off the load immediately
load.off.delay - Turn off the load with a delay (seconds)
shutdown.reboot - Shut down the load briefly while rebooting the UPS
shutdown.stop - Stop a shutdown in progress
