Network UPS Tools
Power Devices support
Table of Contents

Click here to see reports of other supported models from PowerWalker.

Note

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.6.0

Report #1 with driver blazer_usb (detailed comments available)

This device is known to work with driver blazer_usb. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

Some more detailed comments are available after the "Known supported…" sections.

Known supported variables

This device is known to support the following variables (values are just examples):

battery.voltage

40.86

battery.voltage.nominal

36.0

beeper.status

enabled

device.mfr


device.model

HV 1K

device.type

ups

driver.name

blazer_usb

driver.parameter.pollinterval

2

driver.parameter.port

/dev/bus/usb/007/002

driver.version

2.6.0

driver.version.internal

0.03

input.current.nominal

4.0

input.frequency

50.0

input.frequency.nominal

50

input.voltage

227.4

input.voltage.fault

227.2

input.voltage.nominal

220

output.voltage

227.5

ups.delay.shutdown

30

ups.delay.start

180

ups.firmware

00001907

ups.load

15

ups.mfr


ups.model

HV 1K

ups.productid

5161

ups.status

OL BYPASS

ups.temperature

20.5

ups.type

online

ups.vendorid

0665