Network UPS Tools
Power Devices support
Table of Contents

Click here to see reports of other supported models from UPSonic.

Note

When a user reports that a variable/command is not right then it will be highlighted by a red underline.

Bad values/ranges/etc… will get a red dashed outline or red solid left border.

The accompanying explaining comment - if provided - will be emphasized through a red dotted border on the left.

2.2.2

Report #1 with driver megatec_usb (detailed comments available)

This device is known to work with driver megatec_usb, now replaced by the blazer_usb one. It may also work with driver nutdrv_qx.

You can grab a dummy-ups compliant .dev file to simulate this device clicking here.

Some more detailed comments are available after the "Known supported…" sections.

Known supported variables

This device is known to support the following variables (values are just examples):

battery.charge

75.0

battery.voltage

12.70

battery.voltage.nominal

12.0

driver.name

megatec_usb

driver.parameter.pollinterval

2

driver.parameter.port

auto

driver.version

2.2.2

driver.version.internal

1.5.14

input.frequency

49.9

input.frequency.nominal

50.0

input.voltage

244.5

input.voltage.fault

245.0

input.voltage.maximum

247.5

input.voltage.minimum

243.1

input.voltage.nominal

240.0

output.voltage

244.5

ups.beeper.status

enabled

ups.delay.shutdown

0

ups.delay.start

2

ups.load

57.0

ups.mfr

unknown

ups.model

unknown

ups.serial

unknown

ups.status

OL

ups.temperature

25.0

ups.type

standby